ECE 353 Introduction to Microprocessor Systems

ADuC702X Datasheet Rev B Errata:

Page 23, figure 15, the MS3-MS1 pin functions should all be active-low.
Page 34, figure 34, the external memory regions are 128kB, the ending addresses should be 0xX001FFFF, not 0xX000FFFF.
Page 43, Band Gap reference. The Internal Reference Output Enable bit in REFCON must be set to 1 whenever the internal reference is used. The reference will be unstable otherwise.
Page 63, right column, the COMTX register has only write access.
Page 72, left column, 3rd paragraph, 3rd line should read "and 16 output pins".
Page 77, Timer 1. The T1CON register is 32-bits in length.
Page 80, table 79, the memory select pins are active-low.
Page 80, table 80, the memory regions all need to end at 0xX001FFFF, not 0xX000FFFF.
Page 80, figure 69, MS0 & MS1 should be shown as active-low.

 

Copyright © College of Engineering, University of Wisconsin-Madison Content By: morrow@engr.wisc.edu